CoolIT FreeZone CPU

[masterchief]

CoolIT FreeZone CPU

http://www.guru3d.com/admin/imageview.php?image=10305
http://www.guru3d.com/admin/imageview.php?image=10307

Podem ver a review aqui (http://www.guru3d.com/article/processor/438/)

[thehand]

Peltier rula :) ver se isso tem saída

[Denzil]

The product however does come with a couple of quirks. Let me get these out of the way first then:

You can run the fan on the cooler at 7000 RPM (everybody will) and that thing makes noise. I took our DBa meter, was 75 CM away from the PC and did a measurement .. the entire PC made a noise level of 53 DBa and that's just too much. By adjusting the potentiometer that RPM and noise level will go down yet then the effect is pretty average cooling. Since you buy this product for it's high performance I'm convinced everyone will use the highest setting. With that said; the fan solution is something CoolIT needs to focus on as it is really noisy.

The second issue is the sheer size of the unit. In some cases you might run into the issue that you will not be able to close the side-panel without doing some serious Houdini moves. In most cases though, it'll not be a problem. The last negative is simple .. pricing. At 399 USD this product is targeted at the uber enthusiast community that has money to spare. So really, it's very expensive. Also keep in mind that at full utilization the unit alone can consume 50 Watts.

Barulhento, gigante e caro: 400€!

[Eagle]

400 dólares não euros! Parece ser um produto engraçado tem é que ter uma ventoinha forte e estar sempre limpo se não o Peltier pode fazer danos.